Author Topic: Steps for adding Tube Warmup  (Read 959 times)

Offline Spider

  • Administrator
  • Newbie
  • *****
  • Posts: 8
Steps for adding Tube Warmup
« on: May 19, 2016, 11:12:50 am »
ASCEND  AUTO TUBE WARM-UP/ SEASONING

GOTO..KEYOP…SYS CONFIG…VIEW CONFIG
• SELECT RADIO BUTTON  (BY CATORGORY)……SELECT (OTHER).
• SELECT PATTERN VIEW…CHECK PATTERN COPY…CHECK VIEWS.
• BACK TO OTHER..PATTERN (SEE COPY)…RENAME TUBE WARM-UP. COPY 8 TIMES.

* GENERATOR TECHNIQUE SETTINGS

a) OTHER…PATTERN…TUBE WARM –UP
b) SELECT TUBE WARM UP 1, BUCKY = NONE
c) SELECT 50KV..200 MAS..LARGE FOCAL- .1 SEC
d) REPEAT STEPS A THRU C, 7 TIMES INCREASING KV BY 10.

GOTO…PROCEDURE MAPPING CONFIG…OTHER…
ADD TUBE WARM-UP…ADD TO PROCEDURE.

* GOTO VIEW CFG—-VIEW CATORGORY MGT—OTHER—ADD EXAMS—TYPE TUBE WARM UP—PRI CATORGORY—OTHER—TUBE WARM UP—SAVE.
1. CUSTOM FIELD DESCRIPTIONS,..CHANGE TRAUMA DEFAULT TO TUBE WARM UP.
2. CHANGE TRAUMA TO TUBE WARM-UP.
3. CHANGE TRAUMA DEFAULT TO TUBE WARM-UP DEFAULT
4.  THERE IS A FOURTH PLACE IN THE CUSTOM FIELD DESCRIPTIONS THAT HAS TO BE CHANGED FROM TRAUMA TO TUBE WARM-UP. THEN SAVE.  IT WILL REQUIRE A REBOOT AFTER DONE WITH ALL FOUR (4) PLACES.


5. GOTO KEYOP…TUBE WARM UP DEFAULT, Select..NEW TAB ,SELECT 4X5 box, CALL IT TUBE WARM UP.
6. CHANGE PROCEDURE NAME—OTHER—TUBE WARM UP….SAVE.  YOU MUST ATTACH AND SAVE A TUBE WARM PATIENT SO THE PROCEDURE CODE MAPPING LOADS TO THAT TAB WHEN SELECTED.
         
The Trauma box will now be called Tube warm up and is located on the Patient work list.
« Last Edit: May 19, 2016, 11:23:57 am by Spider »

Offline Spider

  • Administrator
  • Newbie
  • *****
  • Posts: 8
Re: Steps for adding Tube Warmup
« Reply #1 on: May 19, 2016, 11:17:07 am »
When you import from backup, the tube warmup patient is disassociated from the procedure.
You have to remove the tab (step 5) and create it again to so you can create and attach a new patient( step 6)